Archive / Technical

RSS feed for this section

840H owner, upgrade to Transformers can be used with the following kit:

840H Transformers-Y6

Hexa-rotor Y parts list:
840H CF Central Frames(Transformers) x1 pack
840H-Folding Landing Gear (Transformers) x1 pack
840H CNC Motor Mount Set (Transformers) x2 pack

840H Transformers-X4-E

Quad-rotor X parts list:
840H CF Central Frames(Transformers) x1 pack
840H-Folding Landing Gear(Transformers) x1 pack

840H Transformers-V6-E

Hexa-rotor V parts list:
840H CF Central Frames(Transformers) x1 pack
Recommended to use:931066-840H-Folding Landing Gear (Transformers) x1 pack

840H Transformers Manual Download
840H Folding Landing Gear (Transformers) Manual Download

540H Folding Landing Gear

Before installing product on the multi-rotor, connect power, test & verify several
times the smooth operation of the folding landing gear.

Q&A for possible issue encountered:

Q: When power connected, no reponse.
A: This unit has long power detection time that can be several tens of seconds, later
you can hear the power up by the gear reaction acoustic.

Q: The Extented landing gear could not fold.
A: Check if M3x8 screw (see drawing 7) is too tight when the landing geat is extended.
If too tight, loosen this screw a little. re-adjust the landing boom leg, unit spacing
and repeated test to confirm the folding/extension actions are smooth.

20131121102128 20131121102156

PRINTING ERROR on specification of CRANE II & CRANE III Packaging Box

Dear Customers,
It has come to our attention a PRINTING ERROR occurred in the specification of CRANE II & CRANE III camera gimbal Packaging Box.
Please note the CORRECT Angle control specification on CRANE 2 packaging box should be:
Side Tilt: +/- 22.5 degree
Vertical tilt: 120 degree
 CRANE 2 packaging box-01
ERROR
CRANE 2 packaging box-02
CORRECT

Please note the CORRECT Angle control specification on CRANE 3 packaging box should be:

Side Tilt: +/- 18.5 degree
Vertical tilt: 60 degree
CRANE 3 packaging box-01
ERROR
CRANE 3 packaging box-02
CORRECT

The +/- sign should be removed for the Vertical tilt degree range.

*The specification is correctly written in CRANE II & III Instruction Manual.
We’ve asked factory to cover-up the packaging error +/- sign with a sticker as temporary fix.
Our sincere apology for any inconvenience caused.
 
GAUI TEAM